COMPLIANCE INFO_1995-1999 - Laserfiche WebLink

Home Browse Search

# 0 0 C Ic lu Flexible Entry Boots Environ offers a complete line of environmentally safe sump entry seals in sizes to seal standard electrical conduit, rigid pipe and flexible pipe. Environ offers Flexible Entry Boots in both 'Studded Ring' and 'Compression Ring' configurations. Both of theSe type entry boots are made of materials suitable for underground burial and exposure to lusts. FEB 3095 I Studded Ring Conduit FES 31O SiudRing Conduit FEB -0150 Expansion Ring Pipe FEB -0200 Expansion Ring r Pipe FEB -0300 Expansion Ring Pipe FEB -9400 Studded Ring Pipe Studded Ring Flexible Entry Boots This style of Flexible Entry Boor mourns to a sum wall by means of stemless steel studs, a compression ring and nut fasteners and seats to the pipe or conduit by using a bard damp. To install this type of boot. it is necessary to first drill a series of smaller stud toles around the opening using a templet and then the boot opening using Ute appropriate size tole saw. Detailed installation instructions are packaged with the boots. 3/4' 1.05 - 2 1.32' 2-3/8" 1-1r2" _ 1.$1° 4-1/4" 2" { 2.37 I 5-1/2' 3" 3.50' y 5-1/2' 4 4.50' I 5-1/2' Expansion Ring Flexible Entry Boots This style of Fmxioie Entry Boot mounts to a mom wall by means of a nylon expansion ring and to the pipe or quit using a band damp. To install this type of boot it is only necessary to drill the boot opening using the appropriate size tole saw. The smaller stud toles are not required. This boot uses an internal expansion ring to create the pressure seal. Detailed instaltabon ' are paclmged with the toots Available soon. Entry Boot Flexibility Angled Entries Round Surface installations All entry boots are designed to provide universal Flexible Entry Boots are designed to permit up to Flexible Entry Boots may be installed on round flexibility for the pipe or conduit providing up and a 30' angle of flexibility for pipe and conduit surfaces which nave a radius diameter greater down, side to side, basic to front movement as entries. Angles greater than 30' could prevent than 30' U50mm). The installation procedures well as angled pipe entries. This flexibility is the boot from sealing around the pipe or conduit are the same as described above except that the important for aligning pipe connections or as a If angled entries are required, make sure the bolt holes snould be made slightly larger after stress relief for the pipe during backfilling and boot opelrrig in the wall has a sanded edge so initial drilling. Only 'Studded Ring' entry boots ground movement as not to damage the entry boot should be used on round surfaces.