Laserfiche WebLink
AML <br /> D. Results of Ties tingtServicing <br /> Software Version Installed: X <br /> Complete the following checklist: <br /> YYes 0 No*- Is the audible alarm operational? <br /> Yes LI No* Is the visual alarm operational? <br /> Yes Q N& Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> �rYes 13 No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with thew=operation? <br /> Q Yes U No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> Er'N/A operational? <br /> M'Yes U No* For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment <br /> Q N/A monitoring system detects a leak,fails to operate,or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) 233umpfrrench Sensors; Q Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? RKes; El No <br /> 0 Yes 13 No* For tank system that utilize the monitoring system as the primary tank overfill warning device (ie. no <br /> 0/N/A mechanical overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank <br /> fill mt(s)and operating property? If so,at what percent of tank cap!Es does the alarm trigger? <br /> 13 Yes* No Was any monitoring equipment replaced?If yes,identify specific sensors,probes,or other equipment replaced <br /> - and list the manufacturer name and model for all replacement parts in Section F.,below. <br /> 0 Yes* No Was liquid found inside any secondayy containment systems designed as dry systems" (Check all that apply)13 <br /> Product; Q Water. If n,describe causes in Section E,below. <br /> Or"Yes E3 No* Was monitoring system set-AT reviewed to ensure roMset s?Attach set up reports,if applicable <br /> Yes Q No* Is all!j!monitoring �ongpEmanufactureen gEifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 3 <br />