Laserfiche WebLink
6) Laminating the seam between <br />VED <br />A - Pre-cut several dozen pieces of 6" wide fiberglass mat to lengths of 20-24". You will need 3 lirof these mat <br />strips for the INSIDE and OUTSIDE joints of each piping sump. 1 2017 <br />B - Mix resin and catalyst together with mix stick thoroughly. ENVIpIONMENTAL HEALTH <br />C - Use paint roller to apply resin generously to a smooth surface. Spread the resin so it 'wets c A*rG iff r than <br />the strip of fiberglass mat. (Fig. C) <br />D - Apply one layer of fiberglass mat to the resin and use the paint roller to add more resin to fully saturate it. (Fig. D) <br />E - Lay down another strip of fiberglass mat, staggering the new layer ONE INCH. This means to offset the next <br />fiberglass strip horizontally (lengthwise) V to the right. Roll more resin into the new strip to saturate it. (Fig. E) <br />F - Repeat Step E, offsetting another strip of fiberglass mat and using the paint roller to add more resin to it until it is <br />fully saturated. (Fig. F) <br />G - Use a Chamfer roller to completely roll over the pre-soaked fiberglass strip while it is on the cardboard, <br />We have created a basic "How To Laminate" video which <br />can be found on our website at www.sbravo.com/videos <br />5 <br />ii-RC-SNAP LOCK -RETROFIT -1 4B <br />