Laserfiche WebLink
na > sem. <br />f� <br />�s <br />7) Leveling and Securing Retrofit Reducerw <br />Apply each "patch" horizontally, centered <br />over the centerline of lamination (seam) <br />where you applied the paste gap -fill and <br />transition. You must cover the tek screws, <br />and overlap the lamination ends <br />together by FOUR INCHES. Use the <br />chamfer roller to roll out any air and <br />flow -coat with remaining resin if you wish. <br />DO NOT DISTURB ANYTHING <br />WHILE LAMINATION IS CURING. <br />Allow for a full cure time. <br />11W <br />ENVIRONIVIE.N T/uL HEAL: <br />DEPif-"01"MENT <br />LAMINATE THE <br />INTERIOR SEAM, <br />3600 AROUND <br />8) Final Assembly <br />After the lamination has cured, inspect for defects / flaws and patch as necessary. <br />To install SNAP -LOCK cover: <br />X) Remove protective wrapper from o -ring seal <br />1) Unlock cams. <br />2) Step -to -seal. <br />3) Lock cams. <br />If you are unfamiliar with this new cover, <br />read all about it at: <br />sbravo.com/snap <br />You can also see a video at: <br />sbravo.com/videos <br />CENTERLINE <br />____ <br />OF LAMINATION <br />It is pre -greased. Keep it clean of dirt / debris. <br />6 ii—RC—SNAPLOCK—RETROFIT-14B <br />