COMPLIANCE INFO_2013-2018 - Laserfiche WebLink

Home Browse Search

Test Method Developed By: ❑ UDC Manufacturer 0 Industry Standard ❑ Professional Engineer ❑ Other (Sped) Test Method Used: ❑ Pressure ❑ Vacuum ® Hydrostatic ❑ Other (Spec) Test Equipment Used: Incon Sump Tester Equipment Resolution: +/- 0.002" EMEMEMEENIMEMEM Rim= UDC #va UDC Manufacturer: Bravo UDC Material: Steel UDC Depth: 12" Height from UDC Bottom to Top of Highest Pipjag Penetration: Located on Bottom Height from UDC Bottom to Lowest Electrical Penetration: Located on Bottom Condition of UDC prior to testing: Good Portion of UDC Tested 2" above pipin& Does turbine shut down when UDC sensor detects liquid (both product and water)?' D Yes ❑ No ®NA Turbine shutdown re onse time N/A Is system programmed for fail- safe shutdown? ❑ Yes ❑ No ® NA Was fail-safe verified to be operational?' ❑ Yes ❑ No ® NA Wait time between applying pressure/vacuum/water and starting test 30 minutes Test Start Time: 1:07 pm Initial Reading (RI): 2.9252 Test End Time: 1:22 pin Final Readin (RF): 2.9252 Test Duration: 15 min. Change in Reading (RF -RI): None Pass/Fail Threshold or Criteria: +/-0.00211 Test Result: El pass 0 :Fail Was sensor removed for testin ? ❑ Yes 0 N 0 NA Was sensor properly replacedand ®Yes ❑ No ®NA verified functional after testing? Comments — (include information on repairs made prior to testing, and recommended follow-up for failed tests) "Sensor functionality was not confirmed. This procedure is not part of the Secondary Containment testing scope of work". Installed Conduit Boot in UDC # 7/8. i If the entire depth of the UDC is not tested, specify how much was tested. If the answer to any of the questions indicated with an asterisk (*) is "NO" or "NA", the entire UDC must be tested. (See SWRCB LG -160)