COMPLIANCE INFO_2006-2018 - Laserfiche WebLink

Home Browse Search

2. 2. Maintenance shall be conducted in accordance with the Scheduled Maintenance section of the ARB approved Installation, Operation, and Maintenance Manual. Vapor Recovery Equipment Defects The following is deemed a defect for the affected fueling point(s) or system. Fueling Points 1. The fueling point shall be removed from service when more than 30% of a nozzle face seal is missing (e.g., a triangular or similar shape in which greater than 2.5 inches of the faceplate circumference is missing (accumulated). 2. The fueling point shall be removed from service when more than 0.375 square inches of a nozzle vapor collection sleeve is missing (e.g., a rectangular shape of greater than nine/sixteenth (9/16) inches or more on each side, a circular shape of eleven/sixteenth (11/16) inches or more in diameter, or a triangular shape of seven/eighth (7/8) inches on the side. 3. The fueling point shall be removed from service when the total slit length in the convolutions exceeds 18 inches as determined by direct measurements. 4. The fueling point shall be removed from service when a hose is found to have greater than 175 ml of gasoline in the vapor side as determined by sections 6.1 to 6.5 of Exhibit 5. Note: Prior to draining gasoline from the vapor side of the VST hose, use VST tool P/N VST -STP -100 and plug the fuel spout. Do not activate dispenser when draining gasoline from the vapor side of the VST hose. 5. The fueling point shall be removed from service when VST system pressure drops exceeding the following conditions as determined by Methodology 1 of TP -201.4: 5.00 inches WC at a flow rate of 60 CFH of Nitrogen; and 8.00 inches WC at a flow rate of 80 CFH of Nitrogen. 6. The fueling point shall be removed from service when the dispensing rate is greater than ten (10) gallons per minute (gpm) or less than five (5) gpm as determined by the applicable provisions of section 6 or 7 of Exhibit 5 or by direct observation for 30 seconds minimum at the maximum hand held position. 7. The fueling point shall be removed from service when any hose has a visible opening as determined by direct observation. 8. The fueling point shall be removed from service when the insertion interlock mechanism allows dispensing when the bellow is uncompressed as determined by direct observation or GDF -09 (see Vapor Recovery Defects List). 9. The fueling point shall be removed from service when the nozzle automatic liquid shut- off mechanisms malfunction in any manner as determined by EPO No. 26-F (See Vapor Recovery Defects List) or direct observation. VST Phase 11 EVR System Including Veeder-Root ISD, Exhibit 2 - VR -204-H