Laserfiche WebLink
10. The fueling point shall be removed from service when any nozzle has a defective vapor <br />valve as determined by Exhibit 7 or when the vapor valve has a leak rate that exceeds <br />0.07 cubic feet per minute at a pressure of two (2) inches WC as determined by <br />TP -201.213. <br />11. The fueling point or system shall be removed from service when any component <br />required by this Executive Order is absent, installed improperly or disconnected as <br />determined by direct observation. <br />System with VST ECS Processor <br />1. The system shall be removed from service when the three ball valves on the VST ECS <br />processor are not locked in the proper operating configuration (Figure 213-2) as <br />determined by direct observation. <br />2. The system shall be removed from service when the ECS membrane processor is not on <br />or in the automatic vapor processor mode as determined by the Diagnostic section of the <br />Pressure Measurement Control (Section 12) of IOM. <br />3. The system shall be removed from service when the VST ECS Processor alarms for <br />emission factor are activated for two consecutive 24 hour periods as determined by <br />direct observation. <br />System with Veeder-Root Vapor Polisher <br />The system shall be removed from service when the ball valve on the Vapor Polisher is <br />not locked in the proper operating configuration (Figure 2B-3) as determined by direct <br />observation. <br />2. The system shall be removed from service when the Vapor Polisher is not in the <br />automatic mode as determined by the Diagnostic section of the Pressure Measurement <br />Control (Section 12) of IOM. <br />VST Phase 11 EVR System Including Veeder-Root ISD, Exhibit 2 - VR -204-H <br />