COMPLIANCE INFO_2013-2018 - Laserfiche WebLink

Home Browse Search

MONIT40ING SYSTEM CERT1F4kAT1dMr-U=jVE[) CERTIFICATION /TEST DATE: Jul 2, 2014 JUL A1. FACILITY A2. OWNER ENVIRONMENTAL EAS Name Quik StopMarket # 76 Name Quik StopMarkets, Inc. I I Address 1030 S. Olive Avenue, Stockton, CA 95215 Address 4567 Enterprise Street, Frem 2,A ENT Phone # 510-657-8500 Phone # 510-657-8500 Contact Roger Batra Contact Debbie Markovich D. RESULTS OF TESTING / SERVICING Make / Model of Monitoring System: Gilbarco EMC Software Version Installed: 327.04 Complete the following checklist: SN# 80850139005001 In Section E below, describe how and when these deficiencies were or will be corrected. E. COMMENTS Replaced the backup battery in the EMC console. Page 2 of 3 ■ Yes TO No* Is the audible alarm operational? ■ Yes ❑ No* Is the visual alarm operational? ■ Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? ■ Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑ Yes ■ Yes ■ Yes ❑ No* ■ N/A If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modems) operational? For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system detects a teak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shutdown? (check all that apply) ❑ Sump/Trench sensors; [I Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor failure/disconnection? For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? _ ❑ No* ❑ N/A ❑ No* ❑ Yes ❑ No* ■ N/A ❑ Yes * ■ No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. ❑ Yes' ■ No Was any liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) El Product; El Water. If yes, describe causes in Section E, below. ■ Yes ❑ No* Was monitoring system set-up reviewed to insure proper settings? Attach set-up reports, if applicable. ■ Yes ❑ No * Is all monitoring equipment operational per manufacture In Section E below, describe how and when these deficiencies were or will be corrected. E. COMMENTS Replaced the backup battery in the EMC console. Page 2 of 3 r's specifications? In Section E below, describe how and when these deficiencies were or will be corrected. E. COMMENTS Replaced the backup battery in the EMC console. Page 2 of 3