COMPLIANCE INFO_1996-2006 - Laserfiche WebLink

Home Browse Search

D. Results of Testing/Servicing Software Version Installed: /,, `/ t mmrl.ete the following checklist: * In Section E below, describe now ana wnen rnese aeliciencaes mere or Will ue correcdeu. • E. Comments: �.i247 T e k OkA 4=vp p4la k1 vz. - ' =; , r r `'a w 0 Page 2 of 3 03/01 ❑ No* Is the audible alarm operational? Yes, 9s ❑ No* Is the visual alarm operational? 0 s ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑ Yes ❑ NQ!- If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) N/A operational? Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check all that apply) ump/Trench Sensors; ispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor failure/disconnection? es; No. ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no OSA mechanical overfill prevention_ valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? % ❑ Yes* UNo Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. Yes* ❑ No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) GFP-ro—diict; EMater. If yes, describe causes. in Section E, below. ❑ Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings?. Attach set up reports, if applicable ❑ Yes 1 ❑ No* Is all monitoring equipment operational per manufacturer's specifications? * In Section E below, describe now ana wnen rnese aeliciencaes mere or Will ue correcdeu. • E. Comments: �.i247 T e k OkA 4=vp p4la k1 vz. - ' =; , r r `'a w 0 Page 2 of 3 03/01