Laserfiche WebLink
Introduction <br /> Dispenser <br /> P <br /> Sum s <br /> Environ offers a line of dispenser sumps which are designed to <br /> prevent fuel leaks and filter spills from escaping into the environment <br /> 000 <br /> „ <br /> underneath fuel dispensers. They provide a means of liquid tight o o ”' <br /> entry for both single and double wall conventional and flexible pipe, 0 ° o 000 <br /> as well as electrical conduit. They allow for easy installation in both °°o °° ° 0 0 0 <br /> new and retrofit construction applications. A variety of optional 0 0 : 0 0 <br /> accessories are available to meet your design specifications. o o° 0 0 0 0 <br /> O O: 0 0 ° 0 <br /> 0 <br /> ::., <br /> 0 0 ::: : 0 <br /> ° 0 :0 00 o <br /> Dispenser Sump Features <br /> • Liquid Tight Dispenser Sump <br /> • Fully Adjustable Stabilizer Bar <br /> • Uses Flexible Entry Boots <br /> • Non-corrodible Polyethylene Sump <br /> • Installs in both new and retrofit installations <br /> • Accommodates single and double wall pipe <br /> • Height adjustable riser section <br /> • Remote draining capabilities <br /> General Information <br /> This product manual is designed to provide the recommended installation procedures and requirements for Dispenser Sumps. Failure to comply with these <br /> instructions and specifications shall void the product warranty. When ordering dispenser sumps make sure to specify the optional components required to <br /> accommodate the designed installation. <br /> Standard Features <br /> H E D Dispenser sumps are available with the following standard and <br /> B accessory components: <br /> C <br /> A-Molded Polyethylene Sump <br /> F B-Steel Mounting Frame <br /> C-6"Anchor Bolts w/Fasteners <br /> e w/Fasteners <br /> D End Plates <br /> E <br /> - Side Struts <br /> A <br /> : :..::: <br /> F <br /> 3/8"Anchor Nuts <br /> G-Flexible Entry Boots (Accessory) <br /> .. <br /> �-- H -Stabilizer Bar Kit (Accessory) <br /> G <br /> Standard Dispenser Sumps Custom Dispenser Sumps <br /> These Standard Dispenser Sumps can be field customized to accommodate These dispenser sumps are available with factory installed Flexible Entry <br /> both flexible and non-flexible piping systems,as well as a variety of different Boots in prescribed locations to accommodate both Flex I and Flex It piping <br /> dispenser models. The appropriate type and number of Stabilizer Bar Kits systems. There are two types of custom sumps,they are Junction Dispenser <br /> and Flexible Entry Boots,used for both pipe and conduit entries, must be Sumps and Terminating Dispenser Sumps,which are available in a variety of <br /> ordered additionally. models to fit most dispensers. <br /> Index <br /> Introduction & Index..............................................................1 Pipe and Conduit Entries......................................................5 <br /> Specifying Accessory Components........................:.............2 Sump Anchoring..........................................................5 <br /> Pre-Installation Assembly.......................................:.............3 Island Installation..................................................................6 <br /> Specifying Shear Valves.......................................................3 Dispenser Sump Specification..............................................6 <br /> Pre-Installation Fabrication...................................................4 Guide Specifications&Warranty.....................................Back (' <br />