Laserfiche WebLink
IslandInstallation <br /> Island Installations Existing Island Retrofit Installations <br /> �`�-- For new installations which have steel island forms,there are two methods of mounting the dispenser For retrofit applications where the islands will <br /> sump to the island form to secure it during concrete pouring. They are as follows: For retrofit remain intact,dispenser sumps can be installed <br /> applications where the islands will remain intact,dispenser sumps can be installed by following these by following the installation procedure below. <br /> installation procedures: <br /> Top Frame Support Underneath Frame Support Concrete Break-Out&Re-Pouring <br /> Cut two 2 x 4's about 8"longer than the width of Island forms can be ordered with adjustable In most retrofit applications it will be necessary to <br /> the island form. Nail a block on each end to cross bar supports pre-installed into the island cut out an opening larger than the dispenser <br /> wedge the 2 x 4 to the edge of the island form. form. This permits the dispenser sumps to be base for existing island. In this application, <br /> Position sump and cross supports in the island secured directly to these supports using the four adequate steel reinforcement should be installed <br /> form in the desired location and attach the sump Adjustable Support Brackets provided with each in the area to be filled with new concrete. <br /> frame to the wood cross supports using four 2" dispenser sump. Refer to the illustration shown <br /> sheet metal screws. below at the lower left. <br /> j <br /> • • � I 1—---- ��Dispenser <br /> Sheet Existing t <br /> Mehl Opening r IL(caon <br /> J it rew I i <br /> tal <br /> Z�q B i Supeports <br /> Supports \ Enlarged I - _ — <br /> - - —— — — — <br /> J <br /> ®, Opening <br /> • <br /> Dispenser Sump Specifications <br /> Y i Y <br /> LI <br /> � I <br /> 12-1/2"all Models <br /> 1"all Models <br /> 5"all Models 30"all Models <br /> 12-1/2' all Models <br /> I—20"all Models --� I---X+2 all Models ---� <br /> Model Dim X Dim Y Model Dim X Dim Y <br /> 2014 10-7/16 14-7/16 2014 16-172 20-1/2 <br /> 2414 11 15 2414 20-3/4 24-3/4 <br /> 2922 17-1/2 21-1/2 2922 24-1/2 28-1/2 <br /> 3215 10-1/2 14-1/2 3215 28 32 <br /> 4422 17-1/2 21-1/2 4422 16-1/2. 20-1/2 <br /> 4614 9-3/4 13-3/4 4614 20-3/4 24-3/4 <br /> 4714 10-1/4 14-1/4 4714 24-1/2 28-1/2 <br /> 4715 11 15 4715 28 32 <br /> 4721 16 21 4721 24-1/2 28-1/2 <br /> 5922 17-1/2 21-1/2 5922 28 32 <br /> 6 <br />