COMPLIANCE INFO_1991-2008 - Laserfiche WebLink

Home Browse Search

-M*BEAUDREAU-, BEAUDREAU ELECTRONICS INC. B. Submersible Pump (single phase only -for three phase pumps, contact Beaudreau Customer Service at 1-800-739-4435): (i) 77te first and most important st e -p is to be sure that uou have shut the power off to the pro-er pump The best way to do this is as follows: (a) Authorize a dispenser for the product that you want to shut off. (b) With your foot or hand check the pump for vibration indicating that the pump is running. (c) Go into the station and turn off the circuit breaker for that product's submersible pump. (d) Recheck the pump with your foot or hand to be sure the pump has stopped. (e) Turn the dispenser that you had authorized off and replace the nozzle. (f) WARNING: Failure to follow this procedure could lead to serious injury or death. (ii) Remove the plug from the electric box on the top of the pump and store the plug near the pump in case you ever have to remove the controller for maintenance. (iii) Determine what fittings you will need to position the controller. A sample for Red Jacket and Tokheim pumps is shown on Figure #3. Assemble the fittings onto the controller and tighten. (iv) Connect the 7 wires as shown on Figure #4. (v) Disconnect the union and carefully position the connected wires into the electrical box. Thread the reducing bushing into the threaded opening, being careful not to scrape or twist the wires. Reconnect and tighten the union. (vi) The sensor installation is the same as for the dispenser. WARNING: Be sure to plug the sensor into the controller plug before turning the power back on; this will keep you from accidentally ruining the controller and voiding the warranty. (vii) Turn the circuit breaker back on and test for proper operation by authorizing a dispenser of that product and feeling the top of the pump for vibration. (vui) To test the cutoff, insert the sensor into a cup of water. The sensor is affected by ambient light, therefore test the sensor below grade and/or shielded from direct light. The pump should shut down when the sensor is placed into at least 3/8" of water. Remove the sensor from the water to restore power to the pump. NOTE: If controller relay cycles or oscillates when sensor is tripped, it is likely that the controller is switching its own power. Check the appropriate wiring diagram to confirm that controller is wired properly. Make sure that the orange/black and red wires are tied to power from the breaker and the orange wire feeds the pump. If problems continue, please contact Beaudreau Customer Service at 1-800-739-4435