Laserfiche WebLink
• <br />E -Upper Frame Installation <br />EA - Clean all surfaces. Apply a generous bead of <br />provided Vulkem to the top edge of the Midframe. Be <br />sure to apply Vulkem to the bolt holes. (Fig. E.1) <br />E.2 - Place the dispenser frame on top of the <br />midframe and align the holes. Secure using provided <br />truss head screws. Apply Vulkem to threads and <br />between parts you are bolting to. Apply Vulkem to the <br />external gap between the midframe and upper <br />frame. After tightening bolts and/or nuts provided and <br />upper frame is secure, apply generous amount of <br />vulkem to seal the nut and threads. <br />E.3- Loosen valve bolts on bracket to allow for <br />adjustability for when you align dispenser and make <br />valve connections. <br />• <br />Midframe <br />Fig. EA <br />While it is common to bead silicone caulk or other sealant along <br />the bottom edge of the dispenser paneling where it meets the <br />island YOU SHOULD NOT DO THIS!! <br />Bravo Systems dispenser frames and conversion frames are purpose built with a tailored Water <br />Splash lip to prevent water from water entering the bottom seams of the dispenser and into the sump <br />below. When you seal this edge, it will cause water from rain or heavy fog to accumulate on the inte- <br />rior of the dispenser and, when it runs down the interior of the dispenser panels, it will accumulate <br />between your seal and our water splash lip, and drain into the sump causing an alarm. If you MUST <br />seal this area on the traffic -facing sides of the dispenser, we suggest leaving a 2-3" gap on the ends <br />to allow water drainage from within. <br />Island, UDC and Dispenser Frame installed <br />and ready for dispenser mounting. <br />12 ii -B8000 -9000 -DW -11B <br />