Laserfiche WebLink
BRAVO ELECTRICAL OFFSET FRAME <br />INSTALLATION INSTRUCTIONS <br />��►/,"�i1�'sTi�/� Make sure all electrical conduits and piping are clear of <br />any equipment or other obstructions in the dispenser. <br />Physically check your hydraulic cabinet for obstructions before any installation begins. <br />BRAVO UNDER DISPENSER CONTAINMENT ELECTRICAL OFFSET INSTRUCTIONS <br />The Frame should be fully installed and sealed with provided Vulkem before conduit installation. <br />2) Make sure all electrical conduits (piping) are clear of any equipment in the dispenser. Physically <br />check your hydraulic cabinet for obstructions before any installation begins. <br />3) Conduits must be run and tightly secured to the sump. <br />4) Pour concrete around outside of Dispenser Sump and within the conduit area. <br />Special Instructions: <br />5) You must Slope concrete within the <br />Electrical Offset opening between the <br />steel frame walls. This area MUST be <br />sloped and MUST be sealed at the areas <br />shown below. <br />Electrical Area <br />4 Concrete Island' d 4 <br />a, <br />a 4' •q s 4. <br />• •a °' a <br />Special Instructions: <br />6) You must seal where concrete or conduit meets <br />steel, as shown. Seal the downside of the slope and <br />the conduit area with Vulkem 116 or TremPro 650. <br />ii -EO -Installation -2-5-08 <br />4 <br />Concrete <br />v, <br />Steel <br />' <br />Lip <br />c <br />O <br />U <br />• <br />U <br />( <br />Sump <br />a <br />W <br />Interior <br />Sealed <br />Areas <br />FSump <br />4. <br />Interior <br />cA <br />s <br />a <br />• <br />. <br />d <br />a. <br />< <br />4 <br />a= <br />ii -EO -Installation -2-5-08 <br />Sloped <br />Concrete <br />Steel <br />' <br />Lip <br />c <br />O <br />U <br />• <br />U <br />( <br />Sump <br />a <br />W <br />Interior <br />Sealed <br />Areas <br />FSump <br />4. <br />Interior <br />ii -EO -Installation -2-5-08 <br />