COMPLIANCE INFO_2009-2018 - Laserfiche WebLink

Home Browse Search

Title 22, CCR 66265.173 (a) Failed to keep containers of hazardous waste closed except when adding or removing hazardous waste. A container holding hazardous waste shall always be closed during transfer and storage, except when it is necessary to add or remove waste. 4 A 55-gallon drum of hazardous waste was found open and not in use at the time of the November 7, 2006, routine inspection at Wilson Way. Title 22, CCR 66266.130(a) Waste fuel filters not stored, transported, or recycled as scrap metal. Used oil filters are to be managed as hazardous waste unless the conditions of this section are met. Health and Safety Code section 25250.22 allows waste fuel filters to be managed as used oil filters with some additional safety factors pursuant to 66266.130. 4Mr. Saini allowed his service technician dispose of his waste fuel filters without proof of scrap metal recycling and without a proper bill of lading. Title 22, CCR 66273.13 (c)(1) Small quantity universal waste handier did not manage universal waste according to these sections. A small quantity handier of universal waste shall contain any lamp in containers or packages that are structurally sound, adequate to prevent breakage, and compatible with the contents of the lamps. Such containers and packages shall remain closed and shall lack evidence of leakage, spillage or damage that could cause leakage under reasonably foreseeable conditions. 4 During the October 18, 2007, routine hazardous waste inspection at Charter Way, several used fluorescent tubes were found propped against the side of the building without any packaging to prevent breakage. it 22, CCR 66273.15 (c) Small quantity universal waste handier was unable to demonstrate the length of time universal waste was accumulated from the date it became a waste or was received. A small quantity handier of universal waste who accumulates universal waste shall be able to demonstrate the length of time that the universal waste has been accumulated from the date it becomes a waste or is received. The handier may make this demonstration by: (1) Placing the universal waste in a container and marking or labeling the container with the earliest date that any universal waste in the container became a waste or was received; (2) Marking or labeling each individual item of universal waste (e.g., each battery or thermostat) with the date it became a waste or was received; (3) Maintaining an inventory system on-site that identifies the date each universal waste became a waste or was received; (4) Maintaining an inventory system on-site that identifies the earliest date that any universal waste in a group of universal waste items or a group of containers of universal waste became a waste or was received; (5) Placing the universal waste in a specific accumulation area and identifying the earliest date that any universal waste in the area became a waste or was received; or (6) Any other method which clearly demonstrates the length of time that the universal waste has been accumulated from the date it becomes a waste or is received. 4 During the October 18, 2007, routine hazardous waste inspection, it could not be demonstrated how long the used fluorescent tubes had been accumulated. 21