COMPLIANCE INFO_1999-2005 - Laserfiche WebLink

Home Browse Search

1.2.8.Federal,state and local codes and regulations always 2.1.2.3.Be sure that all equipment used to lift the tank is rated take precedence over a Xerxes requirement. to handle the load.Refer to the Xerxes Tank Installation Checklist,Tank Handling Data section for tank shipping weight. 1.2.9.Xerxes must authorize—in writing and prior to tank installation—any variation to,or deviation from,this manual's 2.1.2.4.Prepare the unloading and/or storage site by removing instructions. all rocks and debris. 1.2.10.All correspondence regarding variations must be 2.1.2.5.Arrange for sandbags or tires to be used as chocks. retained for any warranty claim to be valid. (See FIGURE 2-1.) 1.2.11. If you have questions or encounter situations not covered in these installation instructions, contact technical Tie support at Xerxes Minneapolis, 612-M7-1890. Downs 1.3.DEFINITIONS Sandbags Tank Tires 1.3.1. For terms related to Xerxes tanks,see FIGURE 1-1. Lifting Lug Service Fitting Standard 4"NPT Half-Coupling Attached Collar(AC) (access to primary tank only) Manway with Fittings Monitor Fitting (acce(access Reservoir - space son ys to)nterstitial interstitial space only) FIGURE 2-1 -- 2.1.3.When hoisting the tank,take the following precautions: Spring t 2 3 4 S Anchor Strap 2.1.3.1. Use the lifting lug(s). Line 5 Location Dome Flat � Arrows Gauge Plates 2.1.3.2.Do not wrap chain or cable around the tank. Flat Number Rib (under all fittings and manways) Seam 2.1.3.3.Use guy ropes to guide the tank when needed. FIGURE 1-1 2.1.3.4.Do not roll the tank to move it. -• -. -. ® ®- ® 2.1.4.A tank larger than 12,000 gallons has multiple lifting lugs. Use all the lugs to move the tank. (See FIGURE 2-2.) 2.1. GENERAL 2.1.1.Although Xerxes corrosion-resistant tanks are rugged, care must be taken so they are not dropped or damaged during delivery,unloading and handling on the job site. AWARNING The tank is heavy and has a large surface area. the tank will roll on sloped surfaces and could be blown about by the wind. Movement of the tank could cause death, serious personal injury or property damage. 30° 2.1.2.Before the tank is unloaded or relocated on the job site Max. (and before preinstallation testing at job site),complete the following steps: 2.1.2.1.Visually inspect the entire exterior surface of the tank to make sure that no shipping or handling damage has occurred. FIGURE 2-2 Look particularly for holes,cracks or deep scrapes. 2.1.2.2.Sign the shipping papers accepting the tank as 2.1.5.Whenever a tank is stored at the site,chock it in place to delivered, prevent rolling. (See FIGURE 2-1.)Tie the tank down if high winds are expected. 2