Laserfiche WebLink
� <br /> Position Strap Clip Tank Minimum Turnbuckle Diameter Minim m <br /> at Tank Top Diameter (by Type) Wire-Rope <br /> Hook Jaw Eye Diameter <br /> c. <br /> Configuration <br /> UPS 12" Deadman TABLE 6-3 <br /> Slav <br /> 6.5.2.The installing contractor is responsible for providing <br /> hardware and anchor points ofsufficient size and strength. <br /> FIGURE 6-1 8.5.3.The particular configuration n[hardware will bodetermined <br /> bythe contractor,the owner orthe owner's representative. <br /> Tank Anchoring Dimensions 6.5.4.Locate the anchor points unshown inTABLE 6-2and <br /> FkGURE64Raferhndimension^E^A|ignall anchor poinbwith <br /> the marked arrowhead symbols 1P.4onthe tanks,within a <br /> tolerance of±1inch. <br /> 8.5.5. For specific information onhardware and its use,consult <br /> the hardware manufacturer orsupplier. <br /> 6.5.G.The installer ioresponsible for using appropriate and <br /> approved engineering practices when fastening wire rope.Refer <br /> horecommendations nfwire-rope manufacturer and supplier, <br /> and follow accepted industry standards when selecting,using, <br /> TABLE 6-2 attaching orconnecting wire rope.(See FIGURE 6-3,FIGURE 64 <br /> and FIGURE 6-5.) <br /> 6.4.HOLD-DOWN STRAPS <br /> 6.41.Only Xerxes straps may beused when anchoring aXerxes tank. ACAUTION <br /> 6.4.2.The locations for hold-down straps oneach tank are Use only appropdately sized hardware with the strap eye <br /> marked unthe tank bythe arrowhead symbols�4. Oversized hardymay damage the strap eye and result hn <br /> ' or �� p�0����� <br /> 6.4.3.Straps personal injury ,'-,—� --�=— <br /> � dimensions mfstrap eye. <br /> ACAUTION <br /> Do not place straps between nbs (except mn4-foot' Strap <br /> diameter banks). Failure to properly place straps may result Clips <br /> in tank <br /> 8.4.4.Data for hold-down straps are given irTABLE 0Jand <br /> FIGURE 6-y. <br /> 8.4.5.Evenly distribute loads bytightening all hold-down straps FIGURE 6-2 <br /> uniformly until they are snug over the ribs but cause no <br /> deflection ufthe tank. 0.5IWhen connecting the end ofehold-down strap to the anchor, <br /> common methods are using odrop-forged turnbuckle orulooped <br /> 8.4.0.Take enintermediate measurement ofthe tank wire rope,nracombination ofboth, axshown i7FIGURE 6-3. <br /> diameter after the straps have been installed and tightened. <br /> (See SECTION /4.} 8.5.8.All exposed metal onthe anchoring system must b*coated <br /> orga|vun��\opn�m�agoinn(connoion� <br /> 6.5.HARDWARE AND ANCHO�N�3POINTS ~=- <br /> 8.5.1.Anchoring hardware must basized according hoTABLE 6-3, O.5.9.When fastening wire rope,use ominimum nftwo clips for <br /> and manufactured boindustry standards and dimensions. o3/8-inohwire rope and three clips for a1/2-inohwire rope on <br /> each termination.See TABLE 6-3for minimum wire-rope diameter. <br />