COMPLIANCE INFO_1999-2005 - Laserfiche WebLink

Home Browse Search

Connecting Probe/Sensor Wiring to the Console Probe and Sensor Wiring Precautions Connecting r / r Wiring MEMM The equipment is used in location where lethal voltages and explosive vapors or flammable fuels may be present. Care must be taken when installing, servicing or replacing parts in the ® system or serious injury or death from explosion,fire or shock may occur. For this system: 1. Comply with the latest National Electric Code,federal, state,and local codes,and any other applicable safety codes. In addition, take necessary precautions during installation,service,and repair to prevent personal injury,property loss and equipment damage. 2. Refer servicing to trained and qualified personnel only. 3. Do not substitute components or intrinsic safety features may be defeated. 4. Be sure AC power is "OFF"before opening the console panel covers and connecting probe and sensor wires. Do not short any voltage across any barrier terminal including sensors or probes. Probe and Sensor Wiring Precautions To The Installer!You Must Read And Understand This Information. Module/Connector Positions and Labeling Most consoles will be shipped with modules installed as ordered.If additional features are added at a later date,modules will be field installed. In all cases,the position of the modules,their respective connectors and the devices wired to the connectors must be recorded to prevent improper replacement during installation or service.A circuit directory is adhered to the back of the right-hand door for this purpose. During programming,module positions and the devices wired to each module are identified and stored in memory.If a connector is removed and reinstalled on a different module after programming,or if an entire module with its connector is removed and reinstalled in a different module slot,the system will not properly recognize the data being received. 33