Laserfiche WebLink
Sealing Field Connections Probe and Sensor Field Wiring <br /> Using thumbs and forefingers as <br /> i shown, bend epoxy sealant package <br /> back and forth until seal between <br /> compound sections has broken. Then <br /> 1 using fingers squeeze package to mix <br /> sealant. <br /> When mixture becomes well blended <br /> and warm, cut off one end of package <br /> ' e and insert the wire nuts and wires <br /> � .: down into the sealant mixture. Use tie <br /> a wrap to close up package around <br /> wires. <br /> • e• • To probe To console <br /> • • or sensor <br /> /Tie wrap <br /> Make sure that the <br /> end of probe or sensor <br /> cable sheathing is <br /> submerged in sealant <br /> / Wire nuts <br /> • To sensor To console <br /> • s <br /> /Tie wrap <br /> Make sure that the end ,4 <br /> of the sensor cable <br /> sheathing is submerged <br /> in sealant <br /> Wire nuts <br /> probes\epxy2&3w.eps <br /> Figure 9.Epoxy Sealing Probe and Sensor Field Connections <br /> 32 <br />