Laserfiche WebLink
D. Results of Testing/Servicin* <br />Software Version Installed: I q . D S <br />+hn rnllnwino Phi-Arlid. <br />• <br />Yes ❑ No* <br />Is the audible alarm operational? <br />Yes ❑ No* <br />Is the visual alarm operational? <br />es ❑ o* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />Y No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />❑ Yes ❑ <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />N/A <br />operational? <br />Yes ❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to opera , or is electrically disconn d? If yes: which sensors initiate <br />positive shut -down? (Check all that apply Sump/Trench Sensors Dispenser Co ainment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnlection? Yes; El No. <br />aI--, ..aa:..a +'U-.�:+nrinn -+-ae +hP nrimnr +nnlr nVATTIII warnino APV1C? ti r nn <br />N/A mechanical overfill prevention_ valve is installed), is the overfill waming alarm visible and audible at the tank <br />fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? % <br />LL3Yes* <br />* No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />❑ Product; ❑ Water. If yes, describe causes. in Section E, below. <br />❑ No* Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />I ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: �D F_ a4 c.. S t.� i� S�tP-�5�►2 Q if / �t �4 i r G <br />j3'l I rJ fry 0* -0 AD OL, <br />