WORK PLANS - Laserfiche WebLink

Home Browse Search

03 December 2007 AGE-NC Project No. 00-0696 Page 5 of 6 van-mounted Geoprobe 5400 direct-push probing unit equipped with 1.25-inch, stainless steel, hollow probing rods. Soil vapor samples will be obtained at depths of approximately three to four feet bsg in each boring. Samples will be collected using a Geoprobe soil vapor assembly. An expendable vapor point will be placed into a point holder at the bottom of an assembly of 1.25-inch diameterhollow drive rods.The assemblywill then be advanced to the specified depth and retracted approximately twelve inches in order to disengage the expendable point and expose a column of strata from which soil vapor can be extracted.A single use, '/4-inch diameter disposable polyethylene tubing is then attached to a tubing adapter equipped with an O-ring to ensure a vacuum- tight seal. The adapter assembly is then lowered through the center of the Geoprobe hollow drive rods to the specified depth and secured by threading into the expendable vapor point holder. Above ground,the surface around the soil vapor sampler will be sealed with a bentonite sealant to prevent ambient air intrusion. To ensure that a reliable soil-vapor sample is collected with no ambient air breakthrough down the probe rod, AGE will apply an appropriate amount of rubbing alcohol (approximately 6 to 8 ounces) to adequately wet a cotton towel; the wetted towel will be completely wrapped around the base of the probe rod where it contacts the surface and the bentonite seal. The end of the polyethylene tubing is attached by a two-way inlet port to a Tedlar bag placed inside an SKC Vac-U-Chamber(lung box)vacuum chamber. A vacuum pump attached to a purge port of the vacuum chamber is then used to purge the exposed soil column, through the sampling tubing and inlet port, until approximately three volumes of soil vapor or ambient air is evacuated through the sampling system.The vacuum chamber is then sealed and the vacuum pump is attached to a vacuum outlet port of the chamber.When vacuum is applied to the chamber,a negative pressure is created around the Tedlar bag,which inflates,allowing the soil vapor sample to enter directly into the bag via the inlet port. When the sample is collected, the negative pressure in the chamber is reduced and the sample bag is sealed,labeled,log on a chain-of-custody form,and place into a dry cooler(room temperature). Subsequently, all of the collected soil vapor samples will be delivered to a CDPH-certified laboratory for analysis of the chemical constituents listed in Section 2.4. After collection of the sample, soil vapor from the polyethylene tubing will be monitored for the presence of volatile organics using a photo-ionization detector(PID)pre-calibrated to isobutylene. 3.5. EQUIPMENT DECONTAMINATION Prior to use,all sampling tools used for sample collection will be thoroughly rinsed with clean water after being washed with a solution of Alconox. All probing rods will be cleaned prior to advancement at each probe boring location. Advanced CeoEnvironmentvl,Inc.