Laserfiche WebLink
STEP 25: INSTALL WARNING PLATT; <br /> Bend the three warning plate ears down then slide the <br /> tie wrap over the warning plate ears and position warn" <br /> Ing plate against riser pipe approximately 1 " below the <br /> adaptor. Tighten the tie wrap securely. The valve is <br /> now fully installed and In operating position. <br /> 0 <br /> NOTE: the warning plate includes 'important warn- <br /> ings, operating parameters, and listing information <br /> and must be installed . i <br /> too <br /> Manufacturer: "OPW" <br /> Model: "71 SO4" <br /> (4" represents size) <br /> Manufacture bate: <br /> "MFG MMYY" <br /> MM=Month YY=Year <br /> Wy,�fnfj <br /> j Plate Figure 26 - Product Identification <br />[i <br /> Figure 23 <br /> SCEP 26: VALVE REMOVAL <br /> The valve can be removed for tank leaktesting, inspec- <br /> tion, etc „ by removing the Rotatable Product Adaptor, <br /> the 4" nipple, and the Jack Screw Kit , Reinstall per the <br /> above instructions. <br /> For testable models only: It is not necessary to re- <br /> move the valve to check poppet movement / function . <br /> See Page 17 for full testing details. <br /> STEP 27: ELECTRONIC LIQUID LEVEL MONITORING <br /> If an electronic level monitor is Installed, it must be cal €- <br /> brated to match the top of the 7150 valve body, which <br /> must correlate with 95% of the actual tank capacity, <br /> 16 <br />