Laserfiche WebLink
RECEIVED <br /> D E QC 01 2017 <br /> Installing the Dispenser Pan Sensor <br /> FNVIRONMENTAI._ HEALTH <br /> DEPARTMENT <br /> This section describes the hardware,requirements,wiring guidelines,and procedures <br /> for installing the Dispenser Pan Sensor with Dispenser Control Interface. <br /> Installation Hardware <br /> The Stand-Alone Dispenser Pan Sensor with Dispenser Control Interface comes with <br /> the following installation hardware: <br /> For applications which require LTL listing: <br /> ❑ Veeder-Root Non-Discriminating Stand-Alone Dispenser Pan Sensor with <br /> Dispenser Control Interface <br /> Part No.847990-001 (Float-Switch Type) <br /> ❑ Veeder-Root Discriminating Stand-Alone Dispenser Pan Sensor <br /> with Dispenser Control Interface <br /> Part No.847990-002(Differentiating type) <br /> For applications which require cUL listing: <br /> ❑ Veeder-Root Non-Discriminating Stand-Alone Dispenser Pan Sensor with <br /> Dispenser Control Interface <br /> Part No.847970-001 (Float-Switch Type) <br /> ❑ Veeder-Root Discriminating Stand-Alone Dispenser Pan Sensor <br /> with Dispenser Control Interface <br /> Part No.847970-002(Differentiating Type) <br /> For both: <br /> ❑ 1 Wiring Kit(Part No.330020-024) <br /> ❑ Installation Instructions <br /> Important cw Mounting brackets are required and must be ordered separately. Use of Veeder-Root <br /> Universal Mounting Kit(Part No. 330020-012)is recommended. <br /> Installation Requirements <br /> Before you install each Dispenser Pan Sensor,consider the following important <br /> requirements: <br /> 1. The sensor should rest in the cup or lowest point of the dispenser pan. <br /> 2. It is recommended that the sensor be mounted in a true vertical position to ensure <br /> proper operation of the sensor. <br /> 3. Ensure that there will be enough room to pull the sensor straight out of the pan if <br /> service is required. <br /> 3 <br />