COMPLIANCE INFO_2009-2012 - Laserfiche WebLink

Home Browse Search

i Traditional Repair Instructions eDDPP-,-jFor Environ "10 Stud 7000 Series" Repair Kit 4PThis kit provides the Traditional Repair parts,using a URBK Repair Boot,for existin5 FRP Pipe from 3.5"to 4.9"CID in Direct Burial applications where the pipe is coming thru the sump wall straight. URBKZ ENV 10-xx ` WARNING.Prepare all surfaces to be bonded prior to completing installation steps below. ForTraditional Environ repairs in Failure tofollow Direct Bursa)applications llow each step will void warranty&may result in premature failure of penetration fitting. This Kit aRollej for renairin>=:Environ FEB 7000 Serles parts Page 1 with pipingfrom 3,5119-49—OD Rev 1 6-23-2009 i General Instructions for: CLEANING:Spray all surfaces to be bonded with DBC Cleaner and allow to air dry or wipe excess with a clean dry cloth. Surfaces must be dry before applying bonder. General Instructions for. BONDING TO POLY SUMPS OR FIBERGLASS SUMPS: Clean,sand and rough up sump surfaces. Clean flitting and ; apply DBD V between Bonding Ring&sump wall. STEP 1: Loosen Num g,pull Back Metal Ring STEP 2: Clean all Repair Components STEP 3: Place Repair Boot i • Clean all repair components with DBC Place the split Repair Boot over the pipe with the n • Remove Nuts prior to installation sealing grooves toward the sump wall I • Pull back metal mounting flange&discard • Cut off old boot&discard • If present,Cut away old insert&discard • Clean off any'paste'or other bonders from Traditional around the Environ body&sump wall, Repair Boot Cleaner • Clean&sand sump wall • Spray Environ Body.&sanded sump wall with DBC cleaner :.. STEP 4: Bond Repair Boot STEP 5:Seal around the old boot&pipe • Apply Zip-Tite to the split Repair Boot. Use 2 of the Seal around the existing boot &pipe if needed. clamps,#132&96,to hold in place while curing. • Apply Zip-Tate to the CDI. Use 1 of the clamps,#72, Apply a thick bead of DRP(or other approved sealer)between the old boot to hold In place while curing. &the pipe,as needed,to fill any cracks or openings. • Leave these clamps in place for approx 30 minutes This area must be sealed before installing the repair boot. i for curing before proceeding to the next step i I s You must seal any open Fill port on top spaces between the pipe &old Boot Diversified Products Manufacturing Inc.Environ Repair Manual Full Version Rev 3 Page 35 of 70