COMPLIANCE INFO_2009-2012 - Laserfiche WebLink

Home Browse Search

i SDP Repair Instructions - IDPM for Shallow Dispenser Pans Repair Kit 4 :AHMBEA-- Prepare all surfaces to be bonded prior to completing installation steps below. WARNING: Failure to follow each step will void warranty&may result in i premature failure of penetration fitting. Q K 5/6 SDP BONDING TO POLY SUMPS: Clean,sand and rough up sump surfaces. Clean i For Environ&TCI fitting and apply DRP to all surfaces to be bonded. BONDING TO FIBERGLASS SUMPS: Clean,sand and rough up sump surfaces. I Materials have been tested Clean fitting and apply DBB V to all surfaces to be bonded. to UL 2005 Protocols for CLEANING:Spray all surfaces to be bonded with DBC Cleaner and allow to air penetration fittings dry or wipe excess with a clean dry cloth. j �-- STEP 1 _ ---------- Remove �—Remove the nuts .: holding boot to pan. Original view of __ Remove the clamp - Shallow Dispenser:: i - - - Cut off and remove Pan boot to be - the existing boot. repaired m= -.- Cutoff and remove —= the insert if present STEP 2 _ =` • Secure the metal mounting ring up by the shear valve so that it is out of the way. • Wrack the upper&lower split Inserts around pipe • Solvent weld each insert together with Zip-Tite. • Gamp inserts&let cure approximately 30 minutes. - f I I STEP 3 • After curing,slide the lower insert into the opening at the base of the - old fitting. • Apply DRP to cover any gaps between the insert&the pipe with - DRP ~_.•_'`._--.� _- i cover any gaps between the insert&the pipe with DRP • The lower insert should sit flush with the base of the old fitting Diversified Products Manufacturing Inc.Environ Repair Manual Full Version Rev 3 Page 59 of 70 1 I i