Laserfiche WebLink
Multi -Sync <br /> How the <br /> Part 1 — The Bonding Ring & Sleeve <br /> Step 1: Clean around part to be repaired <br /> • Clean around the old part <br /> This step varies depending on the <br /> • Cut off the reducer part of the old entry fitting fitting manufacturer, <br /> • Back off the nut See actual installation instructions. <br /> • Clean & Sand the sump wall & Clean the repair <br /> parts with DBC cleaner. Wipe dry. <br /> Step 2: Check the fit of the repair parts <br /> • Check the fit of the "Bonding Ring" and "Sleeve" <br /> around the nut & pipe <br /> Step 3: Bond Split Parts Back Together <br /> • Back off the nut & "Bond" the split parts back <br /> together rc <br /> z <br /> • Let cure for 30 minutes <br /> a — <br /> f � <br /> • Apply "Sealer" to sump side of Bonding Ring, slide <br /> up to sump wall, & thread on Nut <br /> • Do Not Over Tighten. Snug is ok <br /> • Attach the Sleeve, with fill port up. Bond with <br /> DBB III. Set Clamp in place <br /> Lit CIO Multi Sync Repairs 3/11/11 <br />