Laserfiche WebLink
How the Multi -Sync <br /> f ,JJJ,,,JJ11 <br /> _Z <br /> Part 2—The Eccentric Insert & Multi-Sync Reducer Split Eccentric Split Multi-Sync <br /> Step 4: Install & Bond Eccentric Insert& Multi-Sync Reducer Back Together Insert Reducer <br /> • Wrack Eccentric Insert around the pipe - � <br /> • Wrack Multi-Sync Reducer around the pipe <br /> • Apply DBB III to split area on Eccentric Insert, press ends together&clamp <br /> • Apply DBB III to split area on Multi-Sync Reducer, press ends together& clamp � <br /> Step 5: Install The Eccentric Insert& Multi-Sync Reducer <br /> • Dry fit the Eccentric insert. Make sure it fits properly over the pipe & inside the sleeve. <br /> • Dry fit the Multi-Sync Reducer <br /> • Adjust the positions so that they lineup properly with the Repair Sleeve & Pipe. <br /> Note: A proper fit will not cause extra pressure or force to the sleeve and will allow a <br /> longer lasting repair. <br /> • Once you have the part lined up correctly <br /> 1.Pull back the Multi-Sync Reducer& Eccentric Insert <br /> 2.Apply DBB III bonder all around the Eccentric Insert, <br /> 3.Slide Eccentric into the Repair sleeve in the proper position <br /> 4.Apply DBB III bonder all around the Multi-Sync Reducer <br /> 5.Slide the Multi-Sync Reducer into it's proper place <br /> 6.Set the Clamp the around the sleeve &over the Eccentric Insert and tighten "snugly". <br /> 7.Set clamp over reducer end on the pipe &tighten enough to create a seal around the <br /> pipe. <br /> Step 6: Fill the part with DBF II Polysulfide <br /> • Slowly fill the repair with DBF II <br /> • Use the "Remote Fill" option if space is limited around the repair <br /> • Cleanup &you are done <br /> • Can be Hydro-static tested after 1 hour <br /> Lit CIO Multi Sync Repairs 3/11/11 <br />