Laserfiche WebLink
C <br />SUMP WALL <br />Step 3 FIGURE 7 <br />Tighten the nut by inserting a <br />screwdriver, hex Allen wrench, <br />punch, or 1/4" spanner in the nut <br />spanner holes. <br />Note: If taper bonding the con- <br />tainment pipe into the outside <br />bell, tighten the nut again after <br />bonding — but install the adapter <br />before bonding. <br />OPTIONS - OUTSIDE THE SUMP <br />Illustrations for 2" primary/3" containment <br />FIGURE 8 r 3" CONTAINMENT PIPE, <br />TAPERED AND BONDED. <br />2" RED THREAD If PIPE <br />4" X 3" SECONDARY CONTAINMENT <br />TELESCOPING FITTING <br />8.2 <br />i <br />I*] <br />OPEN <br />2" RED THREAD II PIPE <br />4" X 3" RUBBER PIPE REDUCER <br />FERNCO® FLEXIBLE BOOT <br />2" RED THREAD II PIPE <br />4"X 3" RUBBER PIPE REDUCER <br />FERNCO® FLEXIBLE BOOT <br />OPTIONS - INSIDE THE SUMP <br />Illustrations for 2" primary/3" containment <br />FIGURE 9 <br />UE <br />3" X 2" RUBBER PIPE REDUCER <br />FERNCO® FLEXIBLE BOOT <br />11 <br />I� <br />L <br />2" RED THREAD II PIPE <br />OPEN TO SUMP <br />1I <br />2" RED THREAD II PIPE <br />2" RED THREAD II PIPE When ordering the Smith Fiberglass Products sump <br />• adapter, specify Smith Fiberglass Products part numbers: <br />��3" 0599-607-0, 4" 0599-608-0. <br />