Laserfiche WebLink
F. Iii-Tank Gauging/SIR Equipment: Check this box if tank gauging is used only for inventory control. <br /> Check this box if no tank gauging or SIR equipment is installed. <br /> This section must be completed if in-tank gauging equipment is used to perform leak detection monitoring.. <br /> Com lets the follo 'na checklist: <br /> I13CO3 <br /> Yes ❑ No* Has all input wiring been inspected for proper entry and termination,including testing for ground faults? <br /> Yes ❑ No* Were all tank gauging probes visually inspected for damage and residue buildup? <br /> Yes ❑ No* Was accuracy of system product level readings tested? <br /> Yes ❑ No* Was accuracy of system water level readings tested? <br /> ❑ Yes ❑ No* Were all probes reinstalled.properly? <br /> ❑ Yes I ❑ No* I Were all items on the equipment manufacturer's maintenance checklist completed? <br /> *In the Section H,below,describe how and when these deficiencies were or will be corrected. <br /> G. Line Leak Detectors(LLD): ❑ Check this box if LLDs are not installed. <br /> Co fete the follo inz checklist: <br /> Yes ❑ No* For equipment start-up or annual equipment rtification, was a leak simulated to verify LLD performance? <br /> ❑ N/A (Check all that apply) Simulated leak rate: 0 3 g.p.h.; ❑0.1 g.p.h; ❑0.2 g.p.h. <br /> ❑ No* Were all LLDs confirmed operational and accurate within regulatory requirements? <br /> Y ❑ No* Was the testing apparatus properly calibrated? <br /> F444cs ❑ N * For mechanical LLDs,does the LLD restrict product flow if it detects a leak? <br /> ❑ /A <br /> ectronic LLDs,does the turbine automatically shut off if the LLD detects a leak? <br /> gao* <br /> ❑ Yes For electronic LLDs,does the turbine automatically shut off if any portion of the monitoring system is disabled <br /> 01 or disconnected? <br /> ❑ Yes For electronic LLDs,does the turbine automatically shut off if any portion of the monitoring system malfunctions <br /> N or fails a test? <br /> MZYUr o* For electronic LLDs,have all accessible wiring connections been visually inspected? <br /> /A <br /> No* Were all items on the equipment manufacturer's maintenance checklist completed? <br /> *In the Section H,below,describe how and when these deficiencies were or will be corrected. <br /> H. Comments: <br /> Page 3 of 3 03/01 <br />