COMPLIANCE INFO_2011-2012 - Laserfiche WebLink

Home Browse Search

OPW Installation, Operation, and Maintenance Manual, Page 56 ASSEMBLY INSTRUCTIONS IMPORTANT: Each of the numbered steps in the installation instructions are designed as a CHECK LIST to ensure proper installation and trouble free operation of the OPW 71 SO Overfill Prevention Valve. Read and follow these steps carefully, checking them off as you proceed. Figure numbers correspond to step numbers for easy reference. STEP 1: MEASURE Install the OPW Face Seal Adaptor and the OPW Thread -on Spill Container on the Fill Riser (Refer to the Installation Instructions Supplied with the Spill Container). Insert the 71 SO measuring stick through the riser pipe and hook it under the inside of the tank in the lengthwise direction. Mark the measuring stick at the top of the Face Seal Adaptor threads inside the base of the spill container bucket just below the drain valve outlet window (See Figure 1 WA). The top flange on the 71 SO will rest on the Face Seal Adaptor just below the drain valve outlet, and be locked in place between the Face Seal Adaptor and the 4" nipple that is installed in the spill container with the Jack Screw Kit (See Figure 1 A). (For riser pipe configurations other than that shown, consult installation drawings or use other necessary means to measure Dimension "A"). Using a tape measure, measure the distance from the top of the Face Seal Adaptor in the spill container to the bottom of the tank (Dim. "B"). IMPORTANT: Inspect the riser pipe for any foreign material. Over spray from tank relining or any internal burrs inside of pipe must be removed prior to installation. Failure to have an unobstructed riser pipe may prevent proper installation and operation of the valve. The 71SO is designed for installation into schedule 40 riser pipes. The 71 SO cannot be installed into schedule 80 riser pipes. STEP 2: MARK THE TUBE Use the result from STEP 1 and HOW TO LOCATE THE POSITION OF THE 71 SO AT 95% TANK CAPACITY to mark the upper tube. Measure the distance from the seam where the upper tube and valve body meet. For "C" measurements less than or equal to 6-1/2" see Figure 2. For "C" measurements greater than 6-1/2" use a tape measure to mark the calculated upper tube length onto the upper tube. Riser Pipe with Face Seal Adaptor Figure 1 C Executive Order VR -1 02-K Stick A To Tank ig) Top (I.D.) To Tank Figure 1A Measuring Stick Seam Transfer Mark From Stick to Upper Tube (Cut Line) Figure 2 (For "C" less than or equal to 6-112" only) OPW 71 SO Overfill Prevention Valve Page 5 i stick he f r Jack Screw I ( • installation of Face Seal Adaptor i Figure 1A Measuring Stick Seam Transfer Mark From Stick to Upper Tube (Cut Line) Figure 2 (For "C" less than or equal to 6-112" only) OPW 71 SO Overfill Prevention Valve Page 5