Laserfiche WebLink
f{lS4, 1r, <br />i <br />p <br />h SECTION. <br />; <br />II <br />r:ESIVE CUREAV <br />Precautions: <br />r <br />, <br />Cure time is dependent on ambient ten l,cralore. External <br />he.tt rs recommended for cure when anilm. tit tern is- <br />1- A.O. Smith Inland Inc. does nat recommend testing <br />p erature <br />below 70'F. Cure time at 75' F is 4 to 5 hdurs. For cure cycle <br />of 3" through 6" containment pipe with aii pressure <br />u curves: refer to the instructions in the !jts• <br />greater than 10 psig. Maximum- hydrostatic test <br />d •idhes��,e <br />pressure for containment pipe is 25 psig. (NOTE: <br />Some city water pressures <br />r <br />a tit of External heat (such as hot air guns) will shorten the <br />may exceed the ultimate <br />r �ottr ttn5es and is highly recommended for all installations <br />bond strength of the fittings.) <br />iethe`temperature is below 70°F. External heat is <br />�etssertii for temperatures below 50' F. <br />2. Avoid cuntact with the :;ihesive and hardener since <br />R <br />they are capable of causing skin and eye <br />Y. <br />Detect flames should not be used to cure the <br />.trrrtattons <br />Gloves and eye protection are suggested. If cortacr is <br />adhesive. Hoo <br />spots <br />' may cause overheating of the adhesive resulting in a <br />made. (lush with water and wash with soap'and water. <br />Although <br />` <br />bad bond. <br />the hardener is only mi' <br />idiy toxic, 'avoid in - <br />haling fumes by working in well ventilated area. <br />Pipe sections should not be handled or stressed until the <br />line has <br />3. Solvent containers may be <br />glue returned to ambient temfierature. <br />under pressure. ,SJse caw <br />tion when removing <br />`�= <br />the +nnerse5Is. Eye protection is <br />recommended.. <br />t <br />5 <br />R , <br />y <br />_ <br />tic. <br />4 <br />r' s^ <br />