Laserfiche WebLink
E <br />Monitoring System Certification - Page 2 of 3 <br />Site Address: 36 N. Cherokee Ln. ENVORN <br />Oq i%j <br />ff�WT1128/16 <br />D. Results of Testing / Servicing <br />Software Version Installed- 122.00 <br />Complete the following checklist: <br />M Yes <br />0 No* <br />Is the audible alarm operational'.) <br />0 Yes <br />0 No* <br />Is the visual alarm operational? <br />0 Yes <br />0 No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />0 Yes <br />13 No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />0 Yes <br />0 No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />0 N/A <br />operational? <br />a Yes <br />0 No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />0 N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) 09 Sump/Trenob Sensors; 0 Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor fail ure/disconnection? 0 Yes 0 No <br />11 Yes <br />0 No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (ix, no <br />a N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fill point(s) and oeerating proecrIX? If so, at what percent of tank capacity does the alarm trigger? 0 % <br />0 Yes* <br />0 No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all re2lacenient parts in Section E, below. <br />El Yes* <br />M No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />0 Product; 0 Water, If yes, describe causes in Section E, below. <br />Yes <br />0 No* <br />Was monitoring system set-up reviewed to ensure proper settings? (Attach set-ypreporis, tzyp_livable. <br />6 'Yes-- <br />-d-We <br />Is all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />