Laserfiche WebLink
4.8 The 115 VAC receptacle shall be located on the wall as shown in <br />Figure III. <br />4.9 Local codes may require that AC power be permanently wired <br />to the EMS console. In this case, the console power would be <br />run as stated above, but the wires would terminate inside the <br />receptacle box with a cover plate. Power will be connected to the <br />console at time of installation. <br />I W14 1:13 <br />5.0 Manway requirements <br />5.1 Review Figures I and Figures IV thru XII for various probe <br />applications. <br />6.1 Review Figures H and III (EMS Conduit Requirements). <br />6.2 The EMS has been designed to use 3/4 inch conduit. <br />6.3 Conduit should be looped from probe to probe as the probes <br />are wired in parallel. <br />6.4 An EYS fitting is required at each end of the conduit between <br />the EMS console and the first probe. <br />6.5 The conduit for the external probes shall have no other wiring, <br />including the EMS in -tank probe cables. <br />6.6 Figure III shows the proper method to route the conduit from <br />the EYS fittings inside the facility to the console location. <br />6.7 Pull strings should be provided for pulling the annular space <br />probe in double wall fiberglass tank whenever possible. <br />