Laserfiche WebLink
No M-st <br />MML M. <br />AUTOMATICALLY ................. If the leak test was terminated by the EMS, this message is printed. The <br />duration of the test will be no longer than six (6) hours, but could be as little as <br />one (1) hour if no leak was detected. <br />BY CONSOLE OPERATOR.... If the leak test is terminated by the operator from the keypad, this message is <br />printed. <br />BY REMOTE COMMAND ...... If the leak test is terminated by remote communications via telephone. modem <br />or direct connect through the EMS Console's RS232 Communication Port. <br />DUE TO DELIVERY ................ If a delivery is detected during a leak test, the test will be terminated and this <br />message will be printed. <br />DUE TO PROBE ALARM........ If the EMS detects a malfunction of the ATG probe, this message is printed. <br />The local Tidel authorized service dealer should be contacted Immediately <br />at 1-800-678-7577. <br />DUE TO POWER OFF .............. If the power to the EMS is interrupted during the test, the test will be <br />terminated and this message is printed after power is restored. <br />DUE TO THEFT ....................... If a decrease in net gallons is detected that exceeds the user -programmable <br />limit, the test will be terminated, this message is printed and the theft alarm is <br />activated. <br />TANK PARM CHANGE .......... If a programming parameter is changed for the tank or manifold group of tanks <br />under test, the test will be terminated and this message is printed. <br />.2 Gallon Per Hour Leak Test Result Messages <br />NO LEAK DETECTED ............ If a leak rate of less than .2 gallon per hour was detected, this message is <br />printed. <br />LEAK DETECTED ................... If a leak rate of .2 gallon per hour or greater was detected, this message is <br />printed. <br />INFLOW DETECTED .............. If an increase in a volume rate of .2 gallon per hour or greater was detected, <br />this message is printed. <br />PLEASE REPEAT TEST .......... If the data collected during the leak test is not stable, this message is printed. <br />This could be caused by large variations in the ambient or product temperature <br />(e.g., caused by a recent product delivery). This test should be repeated. <br />NOTE: In all cases, the measured leak or inflow rate is shown on the printed Leak Test Disable Report <br />below the line showing the temperature change. <br />15 <br />