Laserfiche WebLink
SWRCB, January 2002 <br />6. PIPING SUMP TESTING <br />Page 4 of 7 <br />Test Method Developed By: ❑ Sump Manufacturer ® Industry Standard ❑ Professional Engineer <br />❑ Other (Specify) <br />Test Method Uses: ❑ Pressure ❑ Vacuum ® Hydrostatic <br />❑ Other S eci <br />Test Equipment Used: Incon TS -STS Sump Testing System <br />Equipment Resolution: 0.001 <br />Sump # 1 Sump # <br />Sump# Sump # <br />Sump Diameter: 36" <br />Sump Depth: <br />45" <br />Sump Material: <br />Fiberglass <br />Height from Tank Top to Highest <br />Piping Penetration: <br />2111 <br />Height from Tank Top to Lowest <br />1711 <br />Electrical Penetration: <br />Condition of sump prior to testing: <br />Good <br />Portion of Sump Tested' <br />27" <br />Does turbine shut down when <br />sump sensor detects either product <br />NA <br />or water? <br />Turbine shutdown response time z* <br />NA <br />Is system programmed for fail-safe <br />shutdown?* <br />NA <br />Was fail-safe verified to be <br />NA <br />operational?* <br />Wait time between applying <br />pressure/vacuum/water and starting <br />30 min. <br />test: <br />Test Start Time: <br />10:11 AM <br />Initial Reading (RI): <br />5.9255" <br />Test End Time: <br />10:26 AM <br />Final Reading (RF): <br />5.9258" <br />Test Duration: <br />2 x @ 15 min. each test <br />Change in Reading (RF -Rt): <br />0.0003" <br />Pass/Fail Threshold or Criteria: <br />0.002 <br />k. P : YI4 <br />�WM <br />'}!a'Nb. <br />�, r"' ' S <br />U � <br />. 1'?2 r•�, .-Sa�i°' 9 ,��{ <br />..dm :. .n <br />_ ? t <br />Was sensor removed for testing? <br />Yes <br />Was sensor properly replaced after <br />11 testing? <br />Yes <br />Comments - (include information on repairs made prior to testing, and recommended follow-up for failed tests) <br />No Repairs Made. <br />If the testing method does not test the entire sump, specify how much of the sump was tested. Methods not testing the <br />entire sump should only be used if the monitoring system provides fail-safe shutdown. (See SWRCB LG -160) <br />2 With the submersible pump running, place the sensor in product (discriminating sensors should be placed in water). The time <br />between placing the sensor in product and the turbine shutting down is the response time. This should be done if the secondary <br />containment method used does not test the entire volume of the sump. <br />* This information is not needed if the entire sump is tested. <br />Revision: <br />