COMPLIANCE INFO_2006-2011 - Laserfiche WebLink

Home Browse Search

MONITWING SYSTEM CERY14EATION CERTIFICATION /TEST DATE: June 6, 2011 Al. FACILITY A2. OWNER Name Quik Stop Market#121 Name Quik Stop Markets, Inc. Address 1196 W. Louise Avenue,Manteca,CA 95336 Address 4567 Enterprise Street,Fremont,CA 94538 Phone# 510-657-8500 Phone# 510-657-8500 Contact Michael Karvelot Contact Michael Karvelot D. RESULTS OF TESTING/SERVICING Make / Model of Monitoring System: Gilbarco EMC Software Version Installed: 330.01 Complete the following checklist: ■ Yes ❑ No* Is the audible alarm operational? ■ Yes ❑ No* Is the visual alarm operational? ■ Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? ■ Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ■ Yes ❑ No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modems) ❑ N/A operational? ■ Yes ❑ No* For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment ❑ N/A monitoring system detects a leak,fails to operate,or is electrically disconnected? If yes:which sensors initiate positive shutdown? (check all that apply) ■ Sump/Trench sensors; ❑ Dispenser Containment Sensors. ■ Yes ❑ No* Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.no ■ N/A mechanical overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger? % ❑ Yes* ■ No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E,below. ■ Yes* ❑ No Was any liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; ■ Water. If yes,describe causes in Section E,below. ■ Yes ❑ No* Was monitoring system set-up reviewed to insure proper settings? Attach set-up reports,if applicable. ■ Yes ❑ No* Is all monitoring equipment operational per manufacturers specifications? * In Section E below,describe how and when these deficiencies were or will be corrected. E. COMMENTS Removed a small amount of water from the 87 STP sump and both the 87 and 91 fill sumps. Monitor went into warm start loop after fail safe. Replaced the ECPU2 board and performed cold start. Perfromed MSC after cold start with inpsector present. ©2011 Walton Engineering,Inc. Page 2 of 3