Laserfiche WebLink
Monitoring System Certification <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 17.02 <br /> Complete the foliowin checklist: <br /> Yes <br /> No* Is the audible alarm operational? <br /> No* Is the visual alarm 2perational? <br /> No* Were all sensors visually!nspected,functionally tested,and confirmed 22erational? <br /> Yes No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> Yes No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modern) <br /> operational? <br /> Yes No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) M Sump/Trench Sensors; a Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? 0 Yes; U No. <br /> Yes U No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> NIA mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s)and o2erat!n�propedRth <br /> y? If so,at what percent of tank ca does e alarm trigger? <br /> I <br /> Yes <br /> Yes <br /> 0 Yes* No Was any monitoring equipment replaced? If yes, identify specific sensors,probes,or other equipment replaced <br /> and fist the manufacturer name and model for all replacement parts in Section E,below. <br /> Yes* No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply)U <br /> Product; Water. If yes,describe causes in Section E,below. <br /> Yes U No* Was monitoring system"reviewed to ensure proper settings?Attach set!T reports,if applicable <br /> Yes U No* Is all mon!iain equi2mento perational Eer manufacturer's s2ecifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 5 <br />