Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: no <br />r`mmnlata tho fnlinwinn rh,arklict- <br />i <br />11 Yes <br />No' <br />Is the audible alarm operational? <br />R Yes <br />rF No* <br />Is the visual alarm operational? <br />pi Yes <br />TF <br />No" <br />Were all sensors visually inspected, functionally tested, and confirmedoperational? <br />R Yes <br />No' <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment veil not interfere with their <br />proper operation? <br />Yes <br />Ej No` <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />® N/A <br />Yes <br />® No' <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system <br />® N/A <br />detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check e that apply) <br />® Sump/Trench Sensors; Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor <br />failure/disconnection? .1 Yes; ? No. <br />H Yes <br />No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill prevention <br />NIA <br />valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent <br />of tank capacity does the alarm trigger? 900% <br />❑ Yes* <br />® No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br />manufacturer name and model for all replacement parts in Section E, below. <br />® Yes' <br />® No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) t] Product; Q Water. If <br />es, describe causes in Section E, below. <br />H Yes <br />No' <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, 4 applicable <br />11 Yes <br />D No <br />Is all monitoring equipment operational per manufacturer's specifications? <br />" In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />Also tested vent box sensor (LS -600), and transition box sensor (LS -600), <br />passed and certified. <br />Monitoring System Certification Page 2 of 4 <br />K <br />Wednesday, September 16, 2015 brittanyl <br />12107 <br />2/21/07 <br />