Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: <br />Complete the follo, <br />ng checklist: <br />❑ Yes ❑ No* <br />Is the audible alarm operational? <br />❑ Yes <br />❑ No* <br />Is the visual alarm operational? <br />❑ Yes <br />❑ No* <br />Were all sensors visually inspected, ,functionally tested, and confirmed operational? <br />❑ Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />❑ Yes <br />❑ No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g.t modem) <br />❑ N/A <br />operational? <br />❑ Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br />Did you confirm Rositive shut -down due to leaks a d sensor failure/disconnection? ❑ Yes; ❑ No. <br />❑ Yes <br />❑No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />❑ N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fillpoint(s) and o erating pEgperlAy? if so at what percent of tank capacity does the alarm trigger? <br />❑ Yes* <br />❑ No <br />Was any monitoring equipment replaced? If yes, identify specific. sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement Earts in Section E, below. <br />❑ Yes* <br />❑ No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />❑ Yes <br />❑ No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if a licable <br />❑ Yes <br />❑ No* <br />Is all monitoring a ui mento erational Eer manufacturer's specifications? <br />* In Section E below, describe how and when these denceenctes were or waw ue cvrrecreu. <br />ir' (`nmmnnfe• <br />Page 2 of 3 A3/Ot <br />