Laserfiche WebLink
a <br /> D. Results of Testing/Servicing <br /> MCI <br /> Software Version <br /> Installed: unknown 11/1/2005 <br /> Com lets the following checklist: <br /> x Yes No* Is the audible alarm operational? <br /> x Yes No* Is the visual alarm operational? <br /> HE <br /> x Yes No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> x Yes No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not <br /> interfere with their proper operation? <br /> FYeNo* <br /> No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modem)operational? <br /> x N/A <br /> Fore pressurized piping systems,does the turbine automatically shut down if the piping secondary containment <br /> N/A monitoring system detects a leak,fails to operate,or is electrically disconnected? If yes:which sensors initiate <br /> positive shut-down?(Check all that apply)_Sump/Trench Sensors _Dispenser Containment Sensors. Did <br /> you confirm positive shut-down due to leaks and sensor failure/disconnection? Yes No. <br /> Yes No* For Tank systems that utilize the monitoring system as the primary tank overfill warning device(ie.,no mechanical <br /> HN/A overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank fill point(s)and <br /> operating properly?If so,at what percent of tank capacity does the alarm trigger? % <br /> Yes _MNo Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and <br /> list the manufacturer name and model for all replacement parts in Section E,below. <br /> Yes _[RNo Was liquid found inside any secondary containment systems designed as dry systems?(Check all that apply) _ <br /> Product; _Water. If yes,describe causes in Section E,below. <br /> Mx Yes No* Was monitoring system set-up reviewed to ensure proper settings?Attached set up reports,if applicable. <br /> TY--es- No* Is all monitoring equipment operational per manufacturer's specifications? <br /> * In Section E below,describe how and when these deficiencies were or will be corrected: <br /> E,Comments: <br /> Monitoring System Certification <br /> Page 2 of 3 03/01 <br /> MCI-Lodi mon.cert.11-01-05.)ds <br />