Laserfiche WebLink
1011101 "all M U A O t N; Iu 1 wo F1111 <br />Test Method Developed By: <br />❑ UDC Manufacturer ® Industry Standard ❑ Professi "' <br />❑ Other (Spec) <br />e <br />Test Method Used: <br />❑Pressure <br />❑ Vacuum ® Hydro, i ��CG <br />❑ Other (Spec() <br />�C� <br />Test Equipment Used: INCON TS -STS <br />Equipment Resolution: 0.0001 <br />UDC # 9/10 <br />UDC # UDC # UDC # <br />UDC Manufacturer: <br />UNKNOWN <br />UDC Material: <br />FG <br />UDC Depth: <br />27" <br />Height from UDC Bottom to Top <br />9„ <br />of Highest Piping Penetration: <br />Height from UDC Bottom to <br />9„ <br />Lowest Electrical Penetration: <br />Condition of UDC prior to <br />FAIR <br />testing: <br />Portion of UDC Tested' <br />14" <br />Does turbine shut down when <br />UDC sensor detects liquid (loth <br />® Yes ❑ No ❑ NA <br />❑ Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA <br />product and water)?* <br />Turbine shutdown response time <br />6 SEC <br />Is system programmed for fail- <br />® Yes ❑ No ❑ NA <br />❑ Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA <br />safe shutdown?* <br />Was fail-safe verified to be <br />®Yes [INo [INA <br />[_1 Yes F1No ElNA [_1 Yes E]No [INA El Yes ❑ No ElNA <br />OP erational?* <br />Wait time between applying <br />pressure/vacuum/water and <br />15 MINS <br />starting test <br />Test Start Time: <br />2:15 <br />Initial Reading (Ri): <br />2.5306 <br />Test End Time: <br />2:30 <br />Final Reading (RF): <br />2.5314 <br />Test Duration: <br />15 MIN <br />Change in Reading RF-Rj: <br />0.0002 <br />Pass/Fail Threshold or Criteria: <br />0.002 <br />Test result: ' + <br />Pass Fail <br />_. <br />?Pass Fail Pass.Fail Fail <br />Was sensor removed for testing? <br />Z Yes No NA <br />Yes 0No NA Yes No ❑ NA LjYesLj-Nol INA <br />Was sensor properly replaced and <br />® Yes ❑ No ❑ NA <br />❑ Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA <br />verified functional after testing? <br />Comments — (include information on repairs made prior to testing, and recommended follow-up for failed tests) <br />' If the entire depth of the UDC is not tested, specify how much was tested. If the answer to My of the questions indicated with an <br />asterisk (*) is "NO" or "NA", the entire UDC must be tested. (See SWRCB LG -160) <br />Secondary Containment Test Results 6 of 7 <br />