Laserfiche WebLink
1 <br />D. Alternate cons ion for new underground storage tanks conto <br />g motor vehictes fuel (Section 2633). <br />(1) monitoring and response plan CSection 26341. <br />(2)/ Underground storage tank composed of.... <br />Y (a) Fiberglass reinforced plastic. <br />(b) Cathodically protected steel. <br />(c) Steel clad with fiberglass reinforced pt ED <br />El <br />(d) other material that complies with section w <br />(3) Floor of leak interception and detection system const stoped to a <br />collection sump (use of membrane liners comply � ' L irements.) <br />(4) Access casings installed in the collection sump of th ary containment system with <br />ackfitl in the interstitial space. The access casing shall meet all of the following: <br />Designed and installed to allow the liquid to flow into the casing. <br />Sized to allow rival of collected Liquid and able to withstand all anticipated applied <br />�tj LY e stresses. <br />Constructed of material that will not be structurally weakened. <br />Screened along entire vertical zone of permeable material. <br />Capable of preventing Leakage of any hazardous substance from the casing. <br />Extend to the ground surface and covered with a locked waterproof cap. <br />Capable of meeting S.J. Co. PHS-EHD Well Standards. <br />Leak interception and detection system shall prevent the Leaked hazardous substance from <br />entering ground water. <br />14. INTERSTITIAL SPACE MONITORING <br />A. <br />visual monitoring CSection 2632 (c) (1)3 <br />(a) Exterior surface and floor beneath tank monitored by direct viewing <br />_ <br />(b) Daily visual inspections <br />_ <br />(c) Liquid level in tank to be recorded at time of inspection <br />We <br />(d) If liquid observed around or beneath primary tank, owner will determine if an unauthorized release <br />has occurred. <br />8 -. <br />Mechanical or electronic monitoring CSection 2632 (c) (2)) <br />V/ <br />(a) Continuous monitoring system connected to an -audible and visual alarm system. C�1 ew <br />Monitoring equipment to be installed <br />Y"' Manufacturer: <br />- ✓ Model Number - <br />• <br />f Sensor Type: Vapor ® Liquid ® Both. <br />+< Sensor/Panel specifications. <br />Location(s) for sensors: <br />Tank: 1. S • S • *10-WOe a Piping: SgGGON C EAAJ-e (Luw%AtL'-{1 pR.ESSul1.� <br />Dispenser: SUtAr-' <br />C. <br />Monitoring and response plan submitted CSection 2632 (d) (1) & (2)). <br />15../ Any special accessories, fittings, coatings, or linings not inherent within the initial design of the 10 tank or <br />doubte-wall UST. CSection 2631 (b)) <br />_ <br />A. Approved by a nationally recognized independent testing organization. <br />8. Demonstration of integrity with the primary and/or secondary containment. <br />9 <br />