Laserfiche WebLink
0 <br />Page of <br />Test Method Developed By: <br />❑ Sump Manufacturer <br />X Industry Standard ❑ Professional Engineer <br />❑ Other (Sped) <br />Test Method Uses: <br />❑ Pressure <br />❑ Vacuum X Hydrostatic <br />❑ Other (Sped) <br />Measuring Equipment Used for Testing: INCON TS -STS V2.1 <br />Sump # D Turl <br />Sump # D Tur2 Sump # <br />Sump Diameter: <br />36" <br />36" <br />Sump Depth: <br />5'-0" <br />5'-0" <br />Sump Material: <br />Fiberglass <br />Fiberglass <br />Height from Tank Top to Highest <br />14" <br />14" <br />Piping Penetration: <br />Height from Tank Top to Lowest <br />20" <br />24" <br />Electrical Penetration: <br />Condition of sump prior to testing: <br />Dry <br />Dry <br />Portion of Sump Tested. <br />2" Past Highest piping <br />2" Past Highest piping <br />penetration <br />penetration <br />Does turbine shut down when <br />sump sensor detects either product <br />Yes <br />Yes <br />or water? <br />Turbine shutdown response time. <br />4 Sec <br />4 Sec <br />Is system programmed for fail-safe <br />Yes <br />Yes <br />shutdown? <br />Was fail-safe verified to be <br />Yes <br />Yes <br />operational? <br />Wait time between applying <br />pressure/vacuum/water and starting <br />15 Min. <br />15 Min. <br />test: <br />Test Start Time: <br />12:34 <br />12:34 <br />Initial Reading W: <br />5.8673 <br />3.8828 <br />Test End Time: <br />12:49 <br />12:49 <br />Final Reading (RF): <br />5.8675 <br />3.8832 <br />Test Duration: <br />15 Min. <br />15 Min. <br />Change in Reading (RF -R,): <br />.0002 <br />.0004 <br />Pass/Fail Threshold: <br />.002 <br />.002 <br />Test Result: <br />Pass <br />Pass <br />Was sensor removed for testing? <br />Yes <br />Yes <br />Was sensor properly replaced after <br />Yes <br />Yes <br />testin ? <br />Comments — (include information on repairs made to facilitate a passing test and indicate whether a <br />permit was obtained for the repairs) <br />All hvdrostatic test performed twice to insure testing results <br />Note: Hydrostatic testing of sumps should, at a minimum, provide for a liquid level that tests the <br />tank/saddle juncture and the highest tank piping system projection into the sump. <br />R.C.U.S.'T ICOM December 2001 <br />