COMPLIANCE INFO_2002-2008 - Laserfiche WebLink

Home Browse Search

Note: Hydrostatic testing of the UDC should, at a minimum, provide for a liquid level that tests to the highest point of piping projection into the conalnment vessel. R.C.U.S.T.COM December 2001 Page of 7. UNDER -DISPENSER CONT NT (UDC) TESTING Test Method Developed By: ❑ UDC Manufacturer X Industry Standard ❑ Professional Engineer ❑ Other (Specify) Test Method Uses: ❑ Pressure ❑ Vacuum X Hydrostatic ❑ Other (Spec) Measuring Equipment Used for Testing: INCON TS -STS V2.1 UDC # Disp 01 UDC # UDC # UDC Manufacturer: Total Containment UDC Material: Plastic UDC Depth: 30" Height from UDC Bottom to 8" Highest Piping Penetration: Height from UDC Bottom to 12" Lowest Electrical Penetration: Condition of UDC prior to Dry / Dirty testing: Portion of UDC Tested. 2" Past highest piping penetration Does turbine shut down when UDC sensor detects either Yes product or water? Turbine shutdown response 4 Sec. time. Is system programmed for fail- Yes safe shutdown? Was fail-safe verified to be Yes operational? Wait time between applying 15 Min pressure/vacuum/water and starting test: Test Start Time: 12:34 Initial Reading (RO: 3.3151 Test End Time: 12:49 Final Reading (RF): 3.3150 Test Duration: 15 Min. Chan a in Reading (RF-&): .0001 Pass/Fail Threshold: .002 Test Result: Pass Was Sensor removed for Yes testing? Was Sensor properly replaced Yes after test in ? Comments — (include information on repairs made to facilitate a passing test and indicate whether a permit was obtained for the repairs) All hydrostatic test performed twice to insure testinp- results Note: Hydrostatic testing of the UDC should, at a minimum, provide for a liquid level that tests to the highest point of piping projection into the conalnment vessel. R.C.U.S.T.COM December 2001