Laserfiche WebLink
0 0 <br /> SWRCB,January 2002 Page-3—of 3 <br /> 5. UNDER-DISPENSER CONTAIN] C)TESTING <br /> Test Method Developed By: 0 UDC Manufacturer x Industry Standard 0 Professional Engineer <br /> 0 Other(Specify) <br /> Test Method Used: 11 Pressure El Vacuum x Hydrostatic <br /> 0 Other(Specify) <br /> Test Equipment Used:Incon is-sts Equipment Resolution:.00 I" <br /> UDC#1-2 UDC#34 UDC#5-6 Sat UDC#6-7 <br /> C Manufacture?: Bravo <br /> UDC Material: Steel <br /> UDC D9 <br /> the 12" <br /> Height from UDC Bottom to Top Ol <br /> of Highest Pi in Penetration: MAR 112 16 <br /> Height from UDC Bottom to 071 <br /> Lowest Electrical Penetration: ENVIBONM MAL <br /> Condition of UDC prior to Clean HEALTH DEPAR11MENT <br /> testing: <br /> Portion of UDC Tested' 1/2 <br /> Does turbine shut down when <br /> UDC sensor detects liquid(both 0 Yes ONo XNA 0 Yes 0 No NA 0 Yes D No NA 0 Yes 0 No NA <br /> product and water)?* <br /> Turbine shutdown response time <br /> Is system programmed for fail- <br /> safe shutdown?* 0 Yes ONo XNA 0 Yes 0 N1 NA 0 Yes 0 No NA 0 Yes 0 No NA <br /> Was fail-safe verified to be 0 Yes ONo XNA 0 Yes 0 Nc NA 0 Yes 0 No NA 0 Yes 0 No NA <br /> operational?* <br /> Wait time between applying 15 min. 15 min. <br /> pressure/vacuum/water and <br /> starting test <br /> Test Start Time: 4:08 <br /> Initial Reading(Li): 4.539 <br /> Test End Time: 4:23 <br /> Final Reading(RF): 4.538 <br /> Test Duration: 15 Min. <br /> Change in Reading(RF-Ri): 0.001 <br /> Pass/Fail Threshold or Criteria: 0.002 <br /> T` sltid Q Fail <br /> Was sensor removed for testing? 0 Yes ONo ONA 0 Yes 0 No X NA 0 Yes 0 No X NA 0 Yes 0 No XNA <br /> Was sensor properly replaced and 11 Yes El No El NA OYes ONo JXNA 0 Yes 0 No X NA 0 Yes 0 No XNA <br /> verified functional after testinc-- <br /> Comments— include information on repairs madeFWor to Cestang; and ecommended ollaw-u oraided tests) <br /> Tightened entry fittim. <br /> If the entire depth of the UDC is not tested,specify how much was tested. Ilf the answer to M of the questions indicated with an <br /> asterisk(*)is"NU'or"NA",the entire UDC must be tested. (See SWRCB11 LG-160) <br />