Laserfiche WebLink
1 • <br /> STEP 7 Apply a bead of Blue Bond 801 around the housing threads <br /> and thread the repair boot onto the housing. <br /> i <br /> L�' 3 <br /> STEP 8 Index the repair boot with the fill tube at the 12:00 position. <br /> ei <br /> STEP 9 Install the split insert around the pipe and apply a liberal ' <br /> bead of Blue Seal Glue along the seam and lightly hold or <br /> clamp until cured. v <br /> r <br /> STEP 10 Install the insert into the repair boot. l <br /> fT <br /> STEP 11 Install the rear clamp and tighten to 65 inch lbs. (Be careful \ , <br /> not to do this until the Blue Bond 801 is cured.) Install the "3, ! <br /> outer clamp loosely so that air can escape between the insert <br /> and the boot while the boot is being filled with Bostik sealant. <br /> Fill the entire boot cavity with Bostik Il00FS sealant. As the <br /> boot fills it will begin to pressurize and push the insert .; <br /> outward. <br /> STEP 12 Tighten the outer clamp to 65 inch lbs. Clean up any excess L <br /> sealant and allow 24-48 hours for Bostik 110OFS sealant to <br /> fully cure. <br /> Ai f <br /> E <br />