Laserfiche WebLink
OPTIONAL: Apply the Bravo <br />Clamps immediately following adhesive <br />application to each side of the pipe. <br />To Install: Tighten the clamp to the pipe <br />approximately 1" from the face of the <br />Flange and hand -tighten each thumb <br />screw so each bolt is evenly snug against <br />the fitting. Install one on each side. <br />When both clamps are snug then <br />proceed to apply a 1/4 - 1/2 turn to each <br />bolt evenly. When the bolts are applying <br />enough force against the Flange, the <br />clamp will slide along the pipe away from <br />the Flange. Evenly turn the bolts until this <br />occurs to maintain an even amount of <br />force against the face of the Flange. <br />After clamps have been installed and. <br />secured, use an adhesive brush or <br />gloved finger to bead the adhesive and <br />keep it from ' sagging or running off the <br />fitting. Spread it around as thick as <br />possible 360° around the two Critical <br />Joints (FIG. 137). Repeat or add <br />additional mixed adhesive to build up a <br />thick, heavy bead at each critical joint. <br />11 <br />CLAMP KIT CHART MODEL # <br />F -20 -FF <br />F -40 -FF Fiffing • <br />ROUND.- REQUIRED <br />IN ADD <br />- <br />.DD • • THE SET SCREWS. DO NOT <br />1 44 NN ITIT <br />.11) Glue all penetration fittings and allow the full cure time per the adhesive kit instructions. <br />.12) After adhesive has fully cured, remove the clamps by backing off the thumbscrews until they <br />disengage from any adhesive that covered them. <br />OPTIONAL: Re -apply adhesive to fill the holes the clamp -bolts left in the adhesive at the face. <br />C) TEb&%TI'NL'G'%Tff 0 U11 R. F=SEKw% I E Si I NSTALLATI'O"k N <br />After all the FF -Series Fiberglass Flange Fittings are installed and have fully cured: <br />For SingleWall: Water level test to a maximum of 2" above the highest Bravo FF -Series Fitting. <br />8 ii -FF -Series -11A <br />