Laserfiche WebLink
Page 7 of 8 <br /> 8. FILL RISER CONTAINMENT SUMP TESTING <br /> Facility is Not Equipped With Fill Riser Containment Sumps ❑ <br /> Fill Riser Containment Sumps are Present,but were Not Tested ❑ <br /> Test Method Developed By: ❑Sump Manufacturer ®Industry Standard ❑Professional Engineer <br /> ❑Other(Specify) <br /> Test Method Used: ❑Pressure ❑Vacuum ®Hydrostatic <br /> ❑Other(Spec) <br /> Test Equipment Used: See attached testing procedures Equipment Resolution: <br /> Fill Sump#87 Fill Sump#91 Fill Sump# Fill Sump# <br /> Sump Diameter: 48" 48" <br /> Sump Depth: 85" 84" <br /> Height from Tank Top to Top of 18" 14" <br /> Highest Piping Penetration: <br /> Height from Tank Top to Lowest 35" 34" <br /> Electrical Penetration: <br /> Condition of sump prior to Fair Fair <br /> testing: <br /> Portion of Sump Tested 2"above highest 2"above highest <br /> penetration penetration <br /> Sump Material&Manufacturer: Fiberglass Fiberglass <br /> Wait time between applying <br /> pressure/vacuum/water and 30 minutes 30 minutes <br /> starting test: <br /> Test Start Time: 10:06am 10:00am <br /> Initial Reading(Ri): 0.1250 0.6963 <br /> Test End Time: 10:21a 10:15am <br /> Final Reading(RF): 0.1244 0.6967 <br /> Test Duration: 15 minutes 15 minutes <br /> Change in Reading(RF-Ri): 0.00064 0.00033 <br /> Pass/Fail Threshold or Criteria: 0.002 0.002 0.002 0.002 <br /> Is there a sensor in the sump? ®Yes ❑No ®Yes ❑No ❑Yes ❑No ❑Yes ❑No <br /> Does the sensor alarm when <br /> either product or water is ❑Yes ❑No ®NA [:]Yes ❑No®NA [:]YesANO❑ ❑Yes ❑No[INA <br /> detected? <br /> Was sensor removed for testing? NYes ❑No ❑NA ®Yes ❑No RNA ❑Yes ❑No ❑ ❑Yes ❑No ❑ <br /> NA NA <br /> Was sensor properly replaced and ®Yes ❑No ❑NA ®Yes ❑No❑NA ❑Yes ❑No® ❑Yes <br /> verified functional after testing? NA El No❑NA <br /> Comments—(include information on repairs made prior to testing, and recommended follow-up for failed tests) <br />