Laserfiche WebLink
t 0 0 1 <br />•Mohitoring System Certification <br />L <br />D. Results of TestingtServicing 0 3 0 2016 <br />Software Version Installed: 330.01 ENVIR )NMLNTAL <br />Complete <br />the follo!"n <br />ecimst: <br />Is the audible alarm operational? <br />ED Yes <br />0 No* <br />Yes <br />❑ No* <br />is the visual alarm operational? <br />qwvvill <br />Yes <br />Fl N 0* <br />Were all sensors visually inspected, functionally tested and confirmed operational? <br />No* <br />Were all sensors installed at lowest point o f secondary containment and positioned so that other iquipment <br />Yes <br />not interfere with their proper operation? <br />❑ Yes <br />0 No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) <br />g N/A <br />operational? <br />Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />0 N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which i ensors initiatel <br />positive shut -down? (Check all that apply) M Sump/Trench Sensors; 0 Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks And sensor failure/disconnection? ED Yes; 0 <br />0 No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning Owice (i.e., no <br />is installed), is the overfill warning alarm visible and audl)le at the tank <br />rYesOYes <br />0 N/A <br />mechanical overfill prevention valve <br />fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm triggep', 90% <br />r_1 Y" <br />0 * <br />0 No <br />I <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equit ment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* <br />ED No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />0 Product; 0 Water. If yes, describe causes in Section E, below. <br />Yes <br />F1 No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if appli ble <br />0-Te7s <br />0 Np!j_ <br />Is all monitoring e manufacturer's specifications? <br />