COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

9. AST will withstand frost-heave XX Yes No AST is anchored,to concrete wall,-set in a_steel_berm, and located in a covered secured lubricants enclosure not subject to weather conditions 10.AST previously relocated? Yes XX No 11.AST Corrosion Protection Tank is covered in paint,with no evidence of external corrosion. Tank has no specific corrosion protection beyond the paint. No part of the AST touches the ground. The base of the AST is steel. raised 1 inch from the steel berm floor. There is no evidence of internal corrosion taking place. Tank's construction material is carbon steel. As this tank is not in any contact with the ground,there is no need for further corrosion protection such as cathodic corrosion protection. 12.AST Spill Prevention Equipment Filling is a remote operation via external pumps. Product is not handled outside of the intended containers. Tank has secondary containment via steel berm which has adequate containment capacity to contain 100%of the product of both tanks set in the berm. Pumps have a check valve to prevent siphoning from tank back thru pick up hoses. Tank has continuous electronic monitoring with alarms&pneumatic auto shut downs at high product levels. Hydraulic hose pick-ups are stored upright when not in use to prevent spillage from drainage of product remaining,in the hose after filling operations. The filling system also has manual ball-valve shut downs at the pumps and at the tanks in the case that the automatic shut down system failed. The manual ball-valves were found to be in the"open"position and in good working condition,with free movement handle and ball-valve. I3. Overfill Protection: AST has continuous electronic monitoring,with electronic monitor BJ Enterprises 007 alarm with visual-alarm for hi-level detection. Alarm actuates and sound with a siren at 103dB when product levels achieve 90% of tank capacity. System also has a BJ Enterprises 007 SV auto shut down when high levels are reached along with manual shut down ball-valves at the pumps and at the tank in case the auto system fails. Alarms were tested at time of inspection and found to be in good working condition. At the pump location,there is also an alarm box which would alert an operator of high product levels in the tanks. O14a:Toxic Considerations: Used mineral-based crankcase oil is the brown-to-black,oily liquid removed from the engine of a motor vehicle when the oil is changed.,it is similar to unused oil except it contains additional chemicals from its use as an engine lubricant.The chemicals in oil include hydrocarbons,which are distilled from crude oil and various additives that im rove the oil's performance. Used oil also contains chemicals formed when the oil is exposed to high temperatures and pressures inside an engine. It also contains some metals from engine parts and small amounts of gasoline,antifreeze,and chemicals that come from gasoline when it burns inside the engine. 14b: Additional Hazardous Considerations: Waste Oil can be ignitable& create fires under certain conditions, are combustible,or have a flash point less than 60°C(140°F),in addition to a slightly corrosive hazard.which can corrode& break down metals over long periods of exposure. It is not normally a reactive nor does it ^� generate large amounts of vapors, which would be an additional fire hazard,however,this tank is fitted with a 2-inch atmospheric vent on the primary tank,which is properly sized to this tank and the venting renuirements as annotated for the listing thru Underwriter's Laboratories. 15. AST secondary containment(material/design/listed) AST has secondary containment via,steel berm to completely capture any leaks from primary vessel. Secondary containment was inspected,is intact and AST is suitable for continued usage. AST sits within a secured-covered lubricants enclosure. Leak detection is visually ascertained via visual inspection of secondary containment area. Steel thickness of the secondary_ containment was measured to.109 in.steel thickness average. 20 points were measured on the berm. The berm containment capacity is 598 eats.gross containment,with 501 gals.containment after displacement; 16. Damage to AST or systems.No damage reported by Owner/Operator. Upon inspection,no evidence of weld breaks, punctures,cracks,or other structural damage to the tank. Leak detection is assured via inspections of the secondary containment. Steel thickness of the primary_vessel was measured to.109 in. average. Steel thickness of the berm was measured to.109 in.average,